SMC Networks PFM7 Series

-36-
No.PF※※-OMJ0006-G
■[F 9] Auto-preset
This function is capable of calculating the approximate set value automatically based on the on-going
operation. (OUT1 only)
<Operation>
Press the or button in function selection mode to display [F 9].
Press the button.
Press the button. Return to function selection mode.
[F 9] Selection of auto-preset completed
Press the button during measurement mode to display [APH].
([APW] for window comparator mode)
Press the button again, and change the flow rate while the display is flashing.
The set value is automatically calculated by pressing the button. The display will return to measurement
mode.
Once setting is performed, auto-preset mode is turned off. It is then possible to confirm the set value by
pressing the button and perform fine adjustment of the set value.
Select auto-preset
[PrS] and the set value are displayed in turn.
Press the or button to select.