T
ROUBLESHOOTING
58
3. Forgotten password
If you have forgotten the administration password you can return the
Switch to its factory default state by dong the following:
1. Remove the power cord from the back of the Switch.
2. Remove all cables from the front-panel ports.
3. Connect port 1 to port 2, on the front panel, using a standard network
cable.
4. Reconnect the power cord to the rear of the Switch.
5. Wait at least 40 seconds before disconnecting port 1 from port 2.
After completing this procedure, the password will be “smcadmin” and the
network address will be returned to the default; 192.168.2.10.
To Next Page
Loading...
