Smeg CW521D - Page 17


‐CW521/531

17
tStP on/off “on” = minimum rinsing temperature as set,
regardlessofintakewatertemperature.
Iftheintakewaterisnothot;thecycledurationmightbea
few seconds longer than the nominal timing, “off” = the
minimum rinsing temperature might be a few degrees
lowerthanthesetting


Rinseaidpumptotaloperatingminutesdisplay.
This value can be reset during pump maintenance‐see
below.


Detergentpumptotaloperatingminutesdisplay.
This value can be reset during pump maintenance‐see
below.






Energyconsumption(kW)display
The Pc option indicates the total kW consumed since
installationofthedishwasherorsincethelatestreset.


Displayofthenumberofcyclesperformed
When scrolling throughtheappliance parameters, the “tc
88888”itemwillalsoappear; thisisthecountofthetotal
cyclesperformedbythedishwashersinceinstallation.
This parameter cannot be modified or reset unless the
softwareisreprogrammed.


CustomisationofdurationofprogramP4.

