‐CW521/531
20
6.8 Regenerationfrequencysetup(modelswithsoftener)
(Defaultvalue:H03;modifytheparametertosuitthemainswaterhardness.
At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with
regeneratingsaltwhennecessary.
Modifythe
valueofthe
parameterby
pressing .
Hardness
(°dH
German
degrees)
Hardness(°dF
French
degrees)
Setting
level
Regeneratio
noff
Regeneration
off
H00
8,5 15 H01
11 20 H02
17 30 H03
22,5 40 H04
28 50 H05
Regenerationcycleduration:12minutes 33,5 60 H06
With values over 60°dF an external water treatment device must be used and the regeneration
frequencymustbesetonH00.
6.9 tStP(minimumrinsingtemperature)function
Modifytheparameter(ON/OFF)bypressing .
Set at “on” for minimum rinsing temperature as set; set at “off” for rinsing regardless of boiler
temperature.
If the parameter is set as “off” and hot intake water is not used, the minimum rinsing temperature
mightbeafewdegreeslowerthanthesetting.
Ifthetermostopdeviceis
set“off”therinsingisnolongermonitoredandtheuserisresponsible
for ensuring that the minimum correct T° are maintained for the tank and boiler. It is particularly
important to check the intake water temperature.
Also refer to the insufficient washing/drying / foam in tank point of the “troubleshooting” section:
restoreTStopONand/orconnecttheappliancetoahotwatersupply
To Next Page
Loading...
Need help?
General
