Smeg CW521D - Service Setting (for After-Sales Service Only); Starting the Peristaltic Pumps - Rapid Filling of Detergent and Rinse Aid Delivery Circuit


‐CW521/531

22
6.14 Servicesetting(forAfter‐SalesServiceonly)

SeeinformationonSmegtech
6.15 Startingtheperistalticpumps–rapidfillingofdetergentandrinseaid
deliverycircuit.
Performaftertheparametermodificationprocedureexplainedinthepreviouspoint.
Indicatorlightsshowing: off;green;orange;flashing.

With the dishwasher powered up, access “programming
mode”bypressingtheon/off buttonforafewseconds;at
the “beep”, release the button and press it again quickly
within0.5seconds.
The peristaltic pumps continue to operate until the same
buttonispressedagain.Therinseaidanddetergentsymbol
lightsremainonas longasthepumps areon; bearin mind
thattherinseaidperistalticpumpfillsthecircuitinabout7
minutes,whileforthedetergentitonlytakes2minutes.
