Smootharc 180 Multiprocess - Welding techniques; Torch movement during welding

3.7 Welding techniques
TIG Welding techniques
60–75°
15–30°
Nozzle
Direction of travel
Welding Rod
Shield gas
Vertical
Tungsten electrode
The suggested electrode and welding rod angles for welding a bead on
plate are shown above. The same angles are used when making a butt
weld. The torch is held 60–75° from the metal surface. This is the same
as holding the torch 15–30° from the vertical.
Take special note that the rod is in the shielding gas during the
weldingprocess.
3.8 Torch movement during welding
Tungsten Without Filler Rod Tungsten With Filler Rod
75°
75°
15°
Welding
direction
Form pool
75°
75°
15°
Welding
direction
Form pool
75°
75°
15°
Tilt torch
75°
75°
15°
Tilt torch
75°
75°
15°
Move torch to front of pool. Repeat.
75°
75°
15°
Add ller metal
75°
75°
15°
Remove rod
75°
75°
15°
Move torch to front of pool. Repeat.
21BOC Smootharc 180 Multiprocess operating manual