Smootharc 180 Multiprocess - Electrical shock; User Responsibility

7BOC Smootharc 180 Multiprocess operating manual
1.3 Electrical shock
• Never touch ‘live’ electrical parts.
• Always repair or replace worn or damagedparts.
• Disconnect power source before performingany maintenance
orservice.
• Earth all work materials.
• Never work in moist or damp areas.
Avoid electric shock by:
• Wearing dry insulated boots.
• Wearing dry leather gloves.
• Working on a dry insulated oor where possible.
1.4 User Responsibility
• Read the Operating Manual prior to installation of this machine.
• Unauthorised repairs to this equipment may endanger the technician
and operator and will void your warranty. Only qualied personnel
approved by BOC should perform repairs.
• Always disconnect mains power before investigating
equipmentmalfunctions.
• Parts that are broken, damaged, missing or worn should be
replacedimmediately.
• Equipment should be cleaned periodically.
BOC stock a huge range of personal protective equipment. This combined
with BOC’s extensive Gas and Gear network ensures fast, reliable service
throughout the South Pacic.
STOP
PLEASE NOTE that under no circumstances should any
equipment or parts be altered or changed in any way from the
standard specication without written permission given by
BOC. To do so, will void the EquipmentWarranty.
Further information can be obtained from Welding Institute of Australia
(WTIA) Technical Note No.7.
Health and Safety Welding
Published by WTIA,
PO Box 6165 Silverwater NSW 2128
Phone (02) 9748 4443