SMORACY BEAST 3680 - SAFETY DECALS; Decal Maintenance and Locations

Copyright 12/14 13 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680 SAFETY DECALS
SAFETY DECALS
Safety Decals located on your Beast Recycler contain useful information to assist you in operating your
equipment safely. Some of the decals on your machine and their location are shown in this section.
It is very important that all decals remain in place and in good condition on your machine. Please follow the
care and instructions given below:
1) You should use soap and water to keep your decals clean. Never use mineral spirits or
any other abrasive cleaners.
2) Replace immediately any missing or damaged decals. If decals are damaged or
removed it is the owner’s responsibility to replace them. The location the decal is going
to be applied to must be clean and dry, and at least 40° F (5°C) before applying decal.
3) When the need arises to replace a machine component with a decal attached, be sure
and replace the decal.
4) Replacement decals are available, and can be purchased from the manufacturer or
your Smoracy, LLC Dealer.
EXAMPLES:
NOTICE
DECAL MAINTENANCE IS THE
RESPONSIBILITY OF THE OWNER OF THIS
MACHINE. KEEP DECALS LEGIBLE. DECALS
(ETC.) ARE AVAILABLE IN OTHER LANGUAGES.
CONTACT:PARTS DEPARTMENT
6750 MILLBROOK RD.
REMUS, MI 49340
PHONE (888) 748-6348
DANGER
DANGER
DANGER
FALLING OBJECTS - STAND CLEAR
STAY CLEAR - MOVING CONVEYOR
FLYING OBJECTS
STAY CLEAR
OR YOU WILL BE
INJURED!