SMORACY BEAST 3680

To Next Page

To Previous Page

Smoracy, LLC

MODEL 3680

OPERATING THE

TETHER REMOTE

The Tether Remote control comes standard with every machine. The system works by means of

electric solenoids on the manual control valves operated through a push button station, which is at the

end of an umbilical cord which is approximately 50 ft. (15.2 m) long . The Tether Remote control

connection is via a Deutsch Socket. Insert plug into socket located on the side of the engine gauge

panel and tighten. Make sure it is secure. On the engine gauge panel move the first switch from

manual to Radio/Tether and second switch to Tether Remote which will allow you to control the machine

from the Tether Remote. For the Tether Remote control to function properly the manual control valves

for the Infeed Conveyor Chain, Feedwheel, and Feedwheel Yoke must be in the off position.

Concave Door Control Switch: (5)

The Concave Door open and close switch is located on the top left side of the remote. To open the

Concave Door, push the switch up. To close the Concave Door, pull the switch down. An indicator on

either side of the Recycler shows Concave Door position.

The Feedwheel Yoke Switch: (3)

The Feedwheel Yoke is located on the top right side of the remote. To raise the Feedwheel Yoke

depress the button. Release the button to lower and float on incoming material.

Feedwheel Motion Switch: (6)

The Feedwheel motion switch is located on the left center of the remote. By pushing the switch up

the Feedwheel will pull material in. To run in the reverse direction the switch needs to be pulled down

and held. To stop the Feedwheel pull switch down to reverse then to center or off position.

The Infeed Conveyor Motion (Chain): (2)

The Infeed Conveyor motion switch is located on the right center of the remote. By pushing the

switch up the Infeed Conveyor chain will pull material in. To run in the reverse direction the switch

needs to be pulled down and held. To stop the Infeed Conveyor chain pull switch down to the reverse

position and then to center or off position.

Engine Shut Down Switch: (1)

The Engine Shut Down switch is located in the bottom center of the remote. To shut down the engine

in an emergency, depress the button. This will not stop everything immediately. This shuts off fuel and

or electrical power to the engine but engine and moving components will coast to a stop. To reset so

engine will start turn key off and back on at the control panel on Recycler.

Throttle Control Switch: (4)

The throttle control switch is located on top of the remote. To increase engine speed, push the

switch to the right. To decrease engine speed, push the switch to the left. This remote switch can only

speed up the engine to the RPM level set with the manual switch in the control cabinet at the Recycler.

CONTROLS

SMORACY BEAST 3680 - Page 29