Copyright 12/14 54 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680 CUTTERTEETH SECTION
CUTTERTEETH APPLICATIONS
Your Cutterhead is fabricated with 2 spirals of tool holders. The spirals wrap the Cutterhead like the red and white
ribbons on a barber pole. Each spiral must contain a complete set (30) of the same tools. Mixing tool types on the
same spiral is not recommended. Improperly installed teeth will not grind properly and may damage the Cuttermill.
Because all applications differ it is important to determine what tooth combinations perform best under different
situations. We encourage you to experiment with different combinations of tools and screens to obtain production,
product and economic goals. We have found the following teeth combinations to work best in these situations:
NOTE: These suggestions are based on our previous experience. Applications vary due to the material being
processed.
TOOTH STYLES APPLICATIONS
1. Logs and Stumps All 1” forged (clean wood)
1/2 splitters and 1/2 splitter fans
1/2 splitter fans and 1/2 1” forged carbide
1/2 splitter fans and 1/2 shingles
2. Green Waste 1/2 splitters and 1/2 splitter fans
1/2 splitters and 1/2 1” fans
1/2 shingles and 1/2 splitter fans
1/2 splitter fans and 1/2 1” forged carbide
3. Pallets 1/2 splitter fans and 1/2 G-55
1/2 splitter and 1/2 pointed shingle fans
4. Shingles/Asphalt 1/2 shingle teeth and 1/2 pointed shingle fans
1/2 square shingle fans and 1/2 pointed fans
1/2 square shingle fans and 1/2 splitter fans
5. Stringy Material/Palm Fronds All 1” carbide teeth
1/2 1” carbide teeth and 1/2 pointed shingle fans
1/2 shingles and 1/2 pointed shingle fans
6. Wet leaves/Wet bark All 1” fan teeth
1/2 splitter fans and 1/2 1” fans
1/2 shingle fans and 1/2 splitter fans
7. Construction/Demolition Material All splitter fans
1/2 splitter fans and 1/2 G-55
1/2 splitter fans and 1/2 Study
8. Fluffy Mulch/Animal Bedding All splitters
1/2 splitter fans and 1/2 shingles
1/2 shingle fans and 1/2 splitters
The G-55 impregnated carbide teeth will work for most all of the above applications and is recommended if the
material contains contaminates. Smoracy, LLC recommends replacing the 6 worst worn teeth per day. DO NOT
discard any teeth still capable of grinding. They can be used to replace broken teeth or can be used in demolition.
This process will keep your Cuttermill running at optimum performance. When using a combination of two different
teeth make sure they are properly installed. Each spiral must contain the same type of tooth. Improperly installed
teeth will not grind properly and may damage the Cuttermill.
DANGER
To Next Page
Loading...