SNAP CIRCUITS BRIC: STRUCTURES - Snap Wires: Use this Mini-Circuit to Test each of the 3-Snap Wires. the Lamp Should Light; Light Post

SNAP CIRCUITS BRIC: STRUCTURES

60 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

13

Project 4 Light Post

3

5

2

4

6

1

2x

9x

6x

2x

LINED

LENS

7x

2x

4x

7x

3X

2x

Table of Contents

If You Suspect You Have Damaged Parts, You Can Follow this Procedure to Systematically2
Determine Which Ones Need Replacing3
- Parts List3
Lamp (L4), Color LED (D8), Blue LED (D9), Blink Red LED (D11), Color2 LED (D12), Melody4
- How to Use Snap Circuits4
- IC (U32), and Battery Holder (B3): Place Batteries in Holder. Place the Lamp Directly Across the5
Jumper Wires (Blue and Orange): Use this Mini-Circuit to Test each Jumper Wire, the Lamp9
Snap Wires: Use this Mini-Circuit to Test each of the 3-Snap Wires. the Lamp Should Light14
You May Order Additional / Replacement Parts At: Www.elenco.com/Replacement-Parts24