14
ATC Toolbox Setup ATC Toolbox Setup
COMPLETE DRAWER TRAINING
From the Main screen select “Setup”.
Select “Drawer Training”.
Select the drawer requiring training. If all drawers require
training select drawer one.
Select “Train Drawer” to begin.
Most boxes will display the message to the right stating that
the cameras have already been trained and do you wish to
proceed. Select “Yes” ONLY if you are sure you wish to
proceed.
NOTE: THIS PROCEDURE WILL COMPLETELY RETRAIN
THE CAMERAS WHICH CAN BE A LENGTHY
PROCESS. IF YOUARE NOT SURE THIS IS THE
PROCEDURE TO FOLLOW GO TO SECTION II
FOR THE ABBREVIATED PROCEDURE.
To Next Page
Loading...