31
Administrator / Toolbox Setup
INSTALLING ADMINISTRATOR SOFTWARE
1. Locate the CD (3-60026AC) that comes with the
Administrator S/W kit (EAK0298J02A). If several
toolboxes are on site each CD contains the exact
same software so access to only one is neces-
sary. Insert the installation CD into the drive on the
administrator PC.
2. Using Windows® Explorer locate and double click
on “ATC Admin.exe” icon. The Administrators
software install program is located under <Cur-
rentVersion\Admin\Installer>.
3. The system will extract some les to the hard drive
for installation.
USING ADMINISTRATOR
PC REQUIREMENTS
Snap-on Level 5 ATC utilizes a stand alone PC with Snap-on provided software to administer the ATC tool
boxes.
PC Minimum Requirements:
Operating Systems:
- Windows®XP Service Pack 2 or 3
- Windows®Vista
- Windows®7
Minimum Hardware Requirements:
- PC with 1.6 gigahertz or higher processor clock speed
- 1 GB RAM (Recommended: 2 GB or greater)
- 300 MB hard drive space (Recommended: additional 150MB per active box per month for archive images)
- Wired or Wireless Networking capabilities compatible with ATC toolbox network
NOTE:
The administrator PC should be connected to the same network as the ATC units that it will be administering
before starting the installation procedure.
4. The ATC Administration Installer will appear while
preparing for installation.
To Next Page
Loading...