Snap-On LEVEL5ATC - ATC Toolbox Software Update Installation

To Next Page

To Previous Page

ATC Toolbox Operation

ATC TOOLBOX SOFTWARE UPDATE INSTALLATION

NOTE: This procedure assumes that the ATC Administration software has been installed in the default installation direc-

tory (c:\snap-on\atc). If a different installation directory was chosen you should contact Snap-on technical support for

update instructions.

1. Turn the power on both the ATC Toolbox and the Administration PC

2. Copy the update les to the administration computer. These les should in-

clude the Administration Updater (ATCAdministrationOnlyUpdater-X.X.X.X.exe)

and the toolbox update le (ATC-X.X.X.X.zip).

3. Double click on the Administration Updater to open the program.

4. The program will display an installation prompt. Click

Yes to begin the update process. Click No to exit the

updater.

5. A “Command Prompt” dialog box quickly appears

showing the status of le update.

6. At the end of the system update a message will appear

conrming a successful operation. Click the OK button

to exit.