38
admin
admin
Administrator / Toolbox Setup
9. If all information is properly entered and depend-
ing on the network speed the ATC system should
come on line shortly.
SETTING UP USERS
1. It is highly recommended that the 1st user that is
setup in the system is the “Master”. This is the ID
access card that was included with the toolbox.
NOTE: After the rst synchronization the ATC service
code can no longer be used to access the ATC unit.
2. If no one is logged into the system click on the
“Maintenance” menu at the top of the screen and
select “Log In”.
3. Log into the system using the Admin credentials.
To Next Page
Loading...