17
ATC Toolbox Setup
ABBREVIATED DRAWER TRAINING
Once a Tool Box has had its drawers trained once, an Ab-
breviated training is generally all that is required to maximize
its efciency.
Follow these steps to complete the abbreviated proce-
dures.
From the Main screen select “Setup”.
Select “Drawer Training”.
Select the drawer requiring training. If all drawers require
training select drawer one.
Select “Train Drawer” to begin.
NOTE: THE NEXT 2 STEPS ARE VERY IMPORTANT!
Most boxes will display the message to the right stating that
the cameras have already been trained and do you wish to
proceed. Select “No” to proceed. Selecting Yes will force
you to perform a complete drawer training.
To Next Page
Loading...