18
ATC Toolbox Setup ATC Toolbox Setup
Select “No” when prompted. Selecting Yes will force you to
perform a high reliability drawer training with tool removal.
The next step asks if you would like to gather images with
tools present. Select “Yes” to continue.
Open the selected drawer making sure ALL tools are pres-
ent. Close the drawer normally. The toolbox will momentarily
lock and then unlock in order to capture all necessary data.
This drawer has been trained. If additional signatures are re-
quired with tools present, press “Continue, otherwise se lect
“Complete”. When collecting additional present signatures
the box will not lock and unlock like it did during the collect-
ing of the rst present signature. Collecting additional pres-
ent signatures is recommended to increase the accuracy of
the system.
NOTE: ADDITIONAL SIGNATURES MAY BE REQUIRED
WHEN TOOLS WITH MULTIPLE SIDES OR IMAG-
ES ARE POSSIBLE, SUCH AS A SCREWDRIVER
WITH TWO COLORS OR THREE SIDES. ROTATE
OR RE-POSITION THOSE TOOLS TO COLLECT
ADDITIONAL IMAGES.
To Next Page
Loading...