Snap-On LEVEL5ATC - Toolbox Setup and Access Configuration

36
admin
admin
Administrator / Toolbox Setup
1. If the Administration software is not already open
click on the ATC Administration Icon on the com-
puter desktop.
TOOLBOX SETUP AND ACCESS
Before adding any users it is recommended that each toolbox is setup using the administration software. Once
each toolbox has been added to the system users and preferences can be added. The Administration PC is ca-
pable of handling many users. Each user will have a unique ID card that allows them access to the ATC toolbox
and various features of the toolbox. Some users may be granted full access. Having full access to the toolbox
will allow that user to train the toolbox (see drawer training). However some users may have only access rights
that will allow them to log into the toolbox and to check out and check it tools. The administration software al-
lows the administer to set up each user with unique access and then duplicate that access for each box. This
eliminates multiple setups of one user on multiple toolboxes.
2. When the software launches for the rst time use
the default Employee # and password to log in
as an administrator. We have chosen “admin”
as the default employee # and “admin” as our
default password. It is recommended to change
the default password to something more secure.
Instructions to change a user password is con-
tained in the Setting Up Users section.
3. Click on the “Box Setup & Access”.
4. Click on the <Add New Box> button.