16
ATC Toolbox Setup ATC Toolbox Setup
Please wait while the data is processed. This may take sev-
eral moments.
Open the drawer being trained and check that all tools are
present. Close the drawer slowly. The toolbox will momen-
tarily lock and then unlock in order to capture all necessary
data.
This drawer has been trained. If additional signatures are re-
quired with tools present, press “Continue, otherwise se lect
“Complete”. When collecting additional present signatures
the box will not lock and unlock like it did during the collect-
ing of the rst present signature. Collecting additional pres-
ent signatures is recommended to increase the accuracy of
the system.
NOTE: ADDITIONAL SIGNATURES MAY BE REQUIRED
WHEN TOOLS WITH MULTIPLE SIDES OR
IMAGES ARE POSSIBLE, SUCH AS A SCREW-
DRIVER WITH TWO COLORS OR THREE
SIDES. ROTATE OR RE-POSITION THOSE
TOOLS TO COLLECT ADDITIONAL IMAGES.
To Next Page
Loading...