Snapper 1 Series

21
JOYSTICK CONTROL ASSEMBLY
(All Models except ZMT2500KH)
ITEM PART NO. DESCRIPTION
1 9-1809 COTTER PIN, 1/8” x 1-1/4” (3)
2 4-3881 SHAFT, Hydro Left Hand
3 4-2638 ARM/HUB Weldment (4)
4 9-1298 NUT, 5/16-18 Hex Nyloc (7)
5 7-3060 PLATE, Hydro Shaft (2)
6 1-1791 RETAINER, 5/16” Bolt (2)
7 9-1296 WASHER, 11/32” Flat (4)
8 9-1508 BOLT, 5/16-18 x 3/4” Carriage, Grade 5 (3)
9 7-2934 BUSHING (notched) (8)
10 1-3072 ROLL PIN, 1/4 x 1” (4)
11 2-3656 HANDLE, Plastic
12 9-0844 ROLL PIN 3/16 x 3/4”
13 4-2599 HANDLE, Joystick Control (Weldment)
14 9-1800 BOLT, 5/16-18 Shoulder (4)
15 3-5533 BLOCK, Joy Stick Control Pivot
16 3-5532 BRACKET, Joystick Mounting
17 9-1812 NUT, 1/4-28 Hex Nyloc (8)
18 9-1303 BOLT, 3/8-16 x 1” Carriage Short Neck (4)
19 4-3871 SHAFT, Joystick Control Pivot
20 9-1917 NUT, 7/16-14 Hex
21 9-1816 ROLL PIN, 1/4 x 2-3/4”
22 1-5753 BALL-JOINT (8)
23 9-1605 NUT, 1/4-28 Hex, Grade 5 or B (8)
24 3-5908 ROD, Threaded 1/4-28 x 2-23/32 (2)
25 4-3880 ROD, Threaded 1/4-28 x 13-21/32 (2)
26 2-2112 SPACER (2)
27 4-3874 PIVOT ARM, Joystick Control Weldment (2)
28 9-1628 WASHER, 13/32” Flat
29 4-3882 SHAFT, Hydro (Right Hand)
MID MOUNT Z-RIDER MANUAL No. 06110