Snapper 1 Series

29
CUTTER HOUSING ASSEMBLY
ITEM PART NO. DESCRIPTION
1 2-9422 BEARING, Sealed (2)
2 2-9270 WASHER, Spindle
3 2-9274 SNAP-RING, Spindle Shaft
4 5-9311 SHAFT, Spindle
5 2-9254 SPACER, Bearing
6 2-9271 SPACER, Blade (4)
7A 2-9246 BLADE, 18” (ZM5200M Mower)
7B 7-3395 BLADE, Low Lift 18” (ZM5201M, ZM5202M Mower)
7C 1-7037 BLADE, High Lift 18” (ZM5202M Mower)
7D 1-7081 BLADE, 21” (ZM6100M & ZM6102M Mowers)
7E 7-3396 BLADE, Low Lift 21” (ZM6101M, ZM6102M Mower)
8 1-6440 WASHER, Beveled
9 6-3234 BOLT, 5/8-11 x 7-1/2” Hex Head Cap, Grade 5
10 2-9275 FITTING, Lube
11 2-9252 HOUSING, Cutter
12 2-9384 VENT, Spindle
13 2-9302 BOLT, 3/8-16 x 1-1/4” Rib Necked (6)
14 2-9249 PULLEY, 5-3/4” O.D.
15 6-3237 NUT, 5/8-11 Hex Flange Grade 5
16 9-1299 NUT, 3/8-16 Hex Nyloc (6)
17 6-3238* SEAL, Nylos
18 1-3370* WASHER
MID MOUNT Z-RIDER MANUAL No. 06110
1
3
14
2
15
7B
9
8
7A
6
4
5
11
16
10
12
13
1
NOTE: 5-4017 (Spindle Housing Sub-Asy.) is made of items 11 & 12 (one each) and item 13 (six each).
*NOTE: For Bearing Pre-Seal Kit (6-3240) installation, discard item 3 and replace with items 17 & 18 as shown.
18
17