Sno-Tek 24E - Page 10

EN – 8
8. Loosen, but DO NOT remove hardware retaining belt
cover and remove belt cover. See Figure 5.
See Figure 6.
9. Remove hardware retaining belt finger and remove
belt finger.
See Figure 7.
10. Remove attachment drive belt from attachment
sheave.
To assist belt removal, slowly pull recoil starter handle
while gently guiding belt out of attachment sheave.
Figure 4
1. Deflector Arm
2. Cable Anchor
3. Deflector Bracket
1
2
3
Figure 5
WARNING: AVOID INJURY. Attachment sheave
edges are sharp. Wear thick gloves to remove
belt from attachment sheave.
Figure 6
Figure 7