EN – 15
6. Reinstall auger housing to frame. See Reinstall Auger
Housing on page 9.
7. Place unit in service position and remove bottom
cover. See Service Position on page 7 and Bottom
Cover Removal on page 11.
See Figure 25.
8. Check attachment brake:
• When attachment clutch is disengaged, brake must
contact attachment belt or pulley, whichever is
closest.
• When attachment clutch is engaged, brake must be
more than 1.6 mm (1/16") away from attachment belt
or pulley, whichever is closest.
IMPORTANT: If attachment clutch / brake is out of
adjustment, refer to Operator’s Manual for adjustment
procedure.
4. Reinstall bottom cover and secure with six hex
screws.
5. Return unit to operating position.
6. Reconnect spark plug wire and fill fuel tank.
IMPORTANT: Check all adjustments after first use.
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
Figure 23
1. Brake Pad
2. Brake Roller
Attachment Clutch Disengaged / Brake Engaged
1
2
Figure 24
1. Brake Pad
2. Brake Roller
Attachment Clutch Engaged / Brake Disengaged
1
2
WARNING: AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
1. Attachment Belt
2. Attachment Pulley
3. Brake Pad
Figure 25
1
2
3
To Next Page
Loading...