Page 2 - 16 UL25/UL32/UL40
TRANSPORTATION
AFTER USE EACH DAY
1. Ensure that the platform is fully lowered.
2. Park the machine on a rm level surface, preferably under cover. Secure against vandals, chil-
dren and unauthorized operation.
3. Turn the chassis key switch to OFF and remove the key to prevent unauthorized operation.
TRANSPORTING THE WORK PLATFORM
FORKLIFT
Forklift the aerial platform from the rear by lifting from the fork pockets shown in Figure 2-10
TRUCK
1. Manoeuvre the machine into the transport position and chock the wheels.
2. Secure the machine to the transport vehicle with chains or straps of adequate load capacity at-
tached to the chassis lifting/tie down points.
DC MODELS
For DC models, prior to transportation, disconnect the plug from the battery box and remove the
battery box from the rear of the machine.
Figure 2-9: Fork pockets
location.
Figure 2-10: Battery box (DC
model).
Figure 2-8: Centre of gravity.
Forklift pockets
Battery
Charger
Centre of gravity
Forklifting is for transportation only. Refer to specica-
tions for weight of the machine and be certain that the
forklift is of adequate capacity to lift the machine.
To Next Page
Loading...
