Page 3 - 5UL25/UL32/UL40
SERVICE AND REPAIR
4. Fill hydraulic reservoir through the dipstick hole with ISO #46 hydraulic uid. The hydraulic res-
ervoir has a 5.7 litres (1.5 U.S. gallon capacity. Ensure that the oil is visible on the end of the
dipstick.
BATTERY MAINTENANCE - DC UNITS ONLY
Electrical energy for the motor is supplied by a 12 volt battery. Proper care and maintenance of the
battery and motor will ensure maximum performance from the lift.
Hazard of explosive gas mixture. Keep sparks, ames and smoking materials away
from batteries.
Always wear safety glasses when working with batteries.
Battery uid is highly corrosive. Rinse away any spilled uid thoroughly with clear
water.
BATTERY INSPECTION AND CLEANING
Check the battery uid level daily, especially if the work platform is being used in a warm, dry
climate. If required, add distilled water only. Use of tap water with high mineral content will shorten
battery life.
If the battery water level is not maintained, a full charge cannot be achieved. This
will create a low discharge rate which will damage the motor/pump unit and void the
warranty.
The battery should be inspected periodically for signs of cracks and in some cases, electrolyte
leakage and corrosion of the terminals. Inspect cables for worn spots or breaks in the insulation
and for broken cable terminals.
Clean battery that shows signs of corrosion at the terminals or onto which the electrolyte has over-
owed during charging. Use a baking soda solution to clean the battery, taking care not to get the
solution inside the cells. Rinse thoroughly with clear water. Clean battery and cable contact sur-
faces to a bright metal nish whenever a cable is removed.
BATTERY CHARGING
Charge the battery at the end of each work shift or when the battery has been discharged; which-
ever occurs rst.
Charge the battery in a well ventilated area. DO NOT charge the battery
when the lift is in an area containing sparks or ames.
Permanent damage to the battery will result if not immediately recharged
after discharging.
NEVER leave the charger operating unattended for more than two days.
NEVER disconnect cables from the battery when the charger is operating.
Keep the charger dry.