Page 3 - 2 UL25/UL32/UL40
INTRODUCTION
This section contains instructions for the maintenance of the work platform. Refer to the general
information section for information relevant to all Snorkel work platform and help in diagnosing and
repair of the machine.
The preventative maintenance table should be used at intervals specied by Snorkel or that of Lo-
cal/National regulations to ensure the aerial platform is in good condition for use.
SPECIAL TOOLS
The following is a list of special tools that are required to perform certain maintenance procedures.
These tools may be purchased from local dealers.
Description Part Number
Spanner Wrench for UL 25/32/40 062521-010
Strap Wrench 062482-000
Tie Rod Tensioner ( 2 required) 062738-000
Tensioner Bracket (2 required) 062739-000
EZCal Caliberation & Diagnostic Tool 3072123
PREVENTATIVE MAINTENANCE
The complete inspection consists of periodic visual and operational checks together with all neces-
sary adjustments to assure proper performance. Daily inspection will prevent abnormal wear and
pro-long the life of all systems. The inspection and maintenance schedule is to be performed at
regular intervals. Inspection and maintenance shall be performed by personnel who are trained
and familiar with mechanical and electrical procedures. Complete descriptions of the procedures
are stated in the table 3-2.
The preventative maintenance table has been designed to be used for machine service and main-
tenance repair.
SERVICE AND REPAIR
Be sure to read, understand and follow all information
stated in the operation section of this manual before
attempting to operate or perform service on any work
platform.
Never perform service on the work platform in the elevating
assembly area while the platform is elevated without rst blocking
the elevating assembly. DO NOT stand in the elevating assembly
area while deploying or storing the brace.
Table 3-1: List of special maintenance tools.
Before performing preventative maintenance, it is important
to get familiar with the operation of the machine.
Never enter the area below the platform when the platform
is elevated.
To Next Page
Loading...
