Snorkel UL40 - Introduction to the Snorkel UL Series; General Description of Work Platform

Page 1 - 1UL25/UL32/UL40
INTRODUCTION
INTRODUCTION
PURPOSE
The purpose of this service and parts manual is to provide instructions and illustrations for
the operation and maintenance of this work platform manufactured by Snorkel.
SCOPE
The manual includes procedures for proper operation, maintenance, adjustment and repair
of this product as well as recommended maintenance schedules and troubleshooting.
GENERAL DESCRIPTION
The work platform consists of the platform, controller, elevating assembly, power module,
control module and chassis.
!
W A R N I N G
!
DO NOT use the work platform without
guardrails properly assembled and in place
PLATFORM
The platform has a reinforced steel oor, 1.1 m (43.75 inches) high guardrails with a mid rail,
152 mm (6 inches) toe boards and an entry gate at the rear of the platform.
Features of the UL25/UL32/UL40 is shown in Figure 1-1.
1. Platform
2. Mast
3. Chassis
4. Outriggers
5. Drop bar
6. Lower Guardrail
Figure 1-1: Work platform
1
2
34
5
6