SOFAR 1~4KTL2-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
Step 2 Lift the SOFAR 1~4KTL2-G3 from the packing case and move
it to the installation position.
To prevent device damage and personal injury, keep
balance when moving the inverter because the inverter is
heavy.
Do not put the inverter with its wiring terminals
contacting the floor because the power ports and signal
ports are not designed to support the weight of the
inverter. Place the inverter horizontally.
When placing the inverter on the floor, put foam or paper
under the inverter to protect its shell.
3.7.Installing SOFAR 1~4KTL2-G3
Step 1 Determine the positions for drilling holes, ensure the hole
positions are level, then mark the hole positions using a marker pen,
use the hammer drill to drill holes on the wall. Keep the hammer
drill perpendicular to the wall, do not shake when drilling, so as not
to damage the wall. If the error of the hole positions is too big, you
need to reposition.
Step 2 Insert the expansion bolt vertically into the hole, pay
attention to the insertion depth of the expanding bolt (should be
deep enough).
Step 3 Align the rear panel with hole positions, fix the rear panel on
the wall by tightening the expansion bolt with the nuts.
Figure 3-8
To Next Page
Loading...
