Sofar 1.1KTL2-G3 - Page 62

SOFAR 1~4KTL2-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 56 -
8.Set Address
19.StartTime
9.Set Input mode
20.Set ElecMeter
10.Set Language
21.Logic interface
11.Set Start Parameter
22.Set Power Ratio
Long press the button to Enter the main interface of "1.Enter
Setting" and long press to enter the setting menu. You can select
the content you want to set by short pressing the button.
Note1: Some settings need to enter the password (the default
password is 0001), when entering the password, short press to
change the number, long press to confirm the current number,
and long press after entering the correct password.If "password
error, try again" appears, you will need to re-enter the correct
password.
1. Set Time
Set the system time for the inverter.
2. Clear Energy
Clean the inverter of the total power generation.
3. Clear Events
Clean up the historical events recorded in the inverter.
4. Set Country
Set up the safety regulation country that meets the current use
conditions and requirements. Before setting this item, ensure that
the “ Enable Set Country ” option are enabled . Please refer to
“7.Enable Set Country” for details.
Table6-1 country code setting