Sofar 3000TL - Tools Required for Installation

SOFAR 1.1K~3KTL User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 14 -
3.3. Tools
Prepare tools required for installation and electrical connections.
Table 3-2 shows the tools required for installation and electrical connections.
NO.
Tool
Model
Function
1
Hammer drill
Recommend drill
dia. 6mm
Used to drill holes on the wall.
2
Screwdriver
wiring
3
Removal tool
Remove PV termin
4
Wire stripper
Strip wire
5
4mm Allen
Wrench
Turn the screw to connect rear
panel with inverter.
6
Crimping tool
Used to crimp power cables
7
Multi-meter
Used to check grounding
8
Marker
Used to mark signs
9
Measuring tape
Used to measure distances
10
Level
Used to ensure that the rear panel
is properly installed