Sofar 3000TL - Main Interface

SOFAR 1.1K~3KTL User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 43 -
When the control board and communication board connection fails, the LCD
display interface as shown in the figure below.
6.3. Main Interface
Normal
------Press “back”
1.Enter Setting
2.Event List
3.SystemInfo
4.Display Time
5.Software Update
(A)
“
Enter Setting
”
Interface as below:
1.Enter
Setting
------Press “back”
1.Set time
12. Safety Voltage
2.Clear Energy
13.Safety Frequency
3.Clear Events
14.Insulation Resistance
4.Set Country
15.Relay Test
5.On-Off Control
16.Reactive Power
6.Relay Command
17.Power Derate
7.Enable Set Country
18.Reflux Power
8. Set Energy
19.MPPT Scan
9.Set Address
20.Logic interface
10.Set Language
21.Set Power Ratio
11.Set Start Parameter
Press "Back" to Enter the main interface of "1.Enter Setting" and press "OK"
to Enter the Setting menu. You can select the content you want to set by pressing
"Up" or "Down".
Note1: Some settings need to enter the password (the default password is
0001), when entering the password, press "Up" or "Down" to change the number,
press "OK" to confirm the current number, and press "OK" after entering the