1. 1. Please choose a wall with sucient load-bearing capacity, mark the drill-
ing position on the wall with a marker, and then use an impact drill to drill
holes on the wall. Please keep the impact drill perpendicular to the wall,
and the depth of the hole is slightly larger than the length of the plastic
expansion pipe when drilling. Please use the back of the product to check
whether the hole position is suitable after drilling. If the error is too large,
please reposition (Note: M5*30 self-tapping screws and plastic expansion
tubes are supplied with the shipment. As shown in the figure below, 120 is
the distance between the two holes, unit: mm).
2. 2. Slowly tap the plastic expansion tube into the drilled hole with a hammer
(As shown below).
3. 3. Fix the M5*30 self-tapping screws with a Phillips screwdriver inside the plas-
tic expansion tube and expose the wall surface about 6.4mm and not more
than 6.7mm. Attach the wall mounting holes on the back of the product to
the screws (As shown below).
Installation and User Manual 19/92
Product Installation
To Next Page
Loading...