4. 4. Connect to a passive DO with the load range of maximum voltage 250VAC/
30VDC; maximum current 3A.
It is recommended that the signal transmission distance does not exceed
10m.
5.8 5.8 Connecting the DI signal cable (Reserva-Connecting the DI signal cable (Reserva-
tion)tion)
1. 1. Use wire strippers to strip the protective layer of the communication cable
by about 15mm, and strip the insulation layer by 8mm~10mm as shown in
the figure below.
Installation and User Manual 33/92
Cable Connections
To Next Page
Loading...