5.10 5.10 Connecting the AI signal cable (Reserva-Connecting the AI signal cable (Reserva-
tion)tion)
1. 1. Use wire strippers to strip the protective layer of the communication cable
by about 15mm, strip the insulation layer by 8mm~10mm, and lead out the
corresponding 1-GND/2-GND/3-GND/4-GND signal cable as shown in the
following figure.
2. 2. Cable install the appropriate size tubular pre-insulated terminal and use
crimping pliers to compress it. Cut off the excess signal wire and wrap it
with heat shrink tubing, and the result is shown below.
Installation and User Manual 35/92
Cable Connections
To Next Page
Loading...