8.2.2 Creating plants8.2.2 Creating plants
After entering SOFAR Cloud, click “Plant” under “Plant list”, and then click “Cre-
ate Plant” in the upper right corner to enter the page of plant creation.
On the page of adding a new power plant, users need to fill in basic informa-
tion, access equipment, and power plant photo information.
(1)Basic information: Installed capacity, plant time zone, Revenue per kwh and
other information should be filled in according to the actual situation, other-
wise it will affect the display of power plant data. After users fill in the informa-
tion, click “Next”.
(2)Add device: as shown in the following figure, the user fills in the SN of
CH1000 and adds CH1000. note that inverter and meter cannot be added
here, refer to section 7.2.3 for inverter and meter additions.
(3) Plant photos: users choose their own photos, and finally click “Save”.
66/92 SOFAR CH1000
SOFAR Cloud /APP Operation
To Next Page
Loading...