2. Tilt the product at a certain angle, snap the top of its back DIN-rail clip
hook into the DIN-rail, then press the lower part of the product to the DIN-
rail, and when you hear a clicking sound, the installation is complete (As
shown in the figure below).
NOTICE NOTICE
−
When removing the DIN-rail, push the DIN-rail firmly toward the upper
edge of the catch and then break out the lower edge of the DIN-rail. Do
not break out the DIN-rail directly. The edges of the DIN-rail are sharp,
please touch them carefully to avoid scratching.
4.3.3 Desktop flat4.3.3 Desktop flat
Place the CH1000 flat on a table with no obstructions around the antenna. As
shown in the figure below.
Installation and User Manual 21/92
Product Installation
To Next Page
Loading...