April 21, 2021 14
16. Remote Monitoring Setup
a. Ethernet Dongle
i. Open Dongle housing
ii. Thread ethernet cable through provided opening and plug into the RJ45 port
iii. Reassemble the dongle housing
iv. Plug dongle into Sol-Ark and secure with screws
v. If all is well, you will see solid red and green lights
vi. Register your dongle via the app or www.mysol-ark.com
b. WIFI (Via Cell Phone or computer)
i. Plug WIFI dongle into Sol-Ark
ii. Using your device look for WIFI networks and select the one that matches the S/N number on your
dongle or the one that starts with “EAP” or “E470-####-####”
▪ Password: 12345678
iii. Once Connected to the Dongle
▪ Follow this instruction on the following pages
To Next Page
Loading...
