You can use any color wire for each of the A, B and G connections, as long as:
The same color wire is used for all A pins the same color for all B pins and the
same color for all G pins
The wire for G is not from the same twisted pair as A or B.
5. Insert the twisted wires into the connector and tighten them with the screws.
6. Connect the connector back to the RS485-1 port.
7. In the meter, ensure the RS485-1 DIPswitch is down. See
Figure 30
.
8. In the meter, set the Modbus address 1-3 of the meter according to table
Table 1
Appendix B: Connecting the Energy Meter To the Inverter 80
EV Charging Single Phase Inverter MAN-01-00629-1.2
To Next Page
Loading...
