Solax X1-Hybrid Series - Introduction; 3.1 Basic Features

3. Introduction
10
11
Introduction Introduction
3.1 Basic features
X1-Hybrid Seires is a high-quality inverter which can convert solar energy to AC
energy and store energy into battery.
The inverter can be used to optimize self consumption, store in the battery for
future use or feedin to public grid. Work mode depends on PV energy and user’s
preference. It can provide power for emergency use during the grid lost by using
the energy from battery and inverter(generated from PV).
System Diagram
►
X1-Hybrid Series is designed with two EPS versions for customer to choose
based on the local rules.
E Version applies to the wiring rules that requires the Live line and Neutral line of
EPS must be disconnected with the Live line and Neutral line of grid. (applies to
most countires)
SolaX
meter
+
-
Battery
DPDT
E-BAR
Main switch
RCD
PV1+
PV1 -
PV2+
PV2 -
RCD
PE
EPS
Load
Inverter
I Version applies to the wiring rules that requires Neutral line of
alternative supply must NOT be isolated or switched (applies to wiring
rules AS/NZS_3000:2012 for Australia and New Zealand).
SolaX
meter
+
-
Battery
E-BAR
Main switch
RCD
PV1+
PV1 -
PV2+
PV2 -
RCD
EPS
Loads
Inverter
Loads
Note!
Please control the home loads, and make sure it’s within the “EPS
output rating” under EPS mode, otherwise the inverter will shutdown
with an “overlaod fault” warning.
Please confirm with the mains grid operator whether there is any
special regulations for grid connection.
•
•
E-BAR