What should I do if my Solcon Controller displays O/C – SHEAR PIN?
If the Solcon Controller shows an O/C – SHEAR PIN error, make sure that the motor isn't stalled or jammed. Check the FLA and FLC settings. Inspect the motor and cable connections. Perform a 'Megger' test to verify the condition of the motor and cable.
General| Type | Soft Starter |
|---|---|
| Rated Control Supply Voltage Us (V) | 110-240 |
| Rated Current Ie (A) | 310 |
| Communication | Modbus RTU |
| Frequency | 50/60 Hz |
| Enclosure Rating | IP20 |
| Control Method | Voltage Ramp |
| Ambient Temperature | -10°C to +50°C |
| Humidity | 95% non-condensing |
Read manual carefully before operating equipment and follow all instructions provided.
Internal components at mains potential are dangerous; contact can cause severe injury or death.
Criteria for selecting the correct RVS-DN based on motor current.
Wiring for dual adjustment and short circuit protection.
Setup and configuration for inside delta motor connections.
Operating temperature range and heat dissipation calculations for RVS-DN units.
Configuration of dip switches for various functions.
Switch for selecting main or generator parameter modes.
Enables advanced parameter settings for special applications.
Procedures for accessing and performing special functions in TEST/MAINTENANCE mode.
Details on built-in protections and fault reset procedures.
Step-by-step guide for the standard motor starting procedure.
Troubleshooting steps for Over Current/Shear Pin faults.
Troubleshooting steps for overload and under current protection trips.
Troubleshooting steps for under voltage, over voltage, and phase loss faults.
To Next Page
