THERMOCUBE II 200-650W THERMOELECTRIC CHILLER MANUAL 52-14790-1
SOLID STATE COOLING SYSTEMS, 167 MYERS CORNERS ROAD, WAPPINGERS FALLS, NY 12590 44
TELEPHONE: (845) 296-1300, FAX: (845) 296-1303, WEB: WWW.SSCOOLING.COM VERSION M2
ACGIH - American Conference of Governmental Industrial Hygienists
OSHA - Occupational Safety and Health Administration
Engineering Measures Ensure adequate ventilation, especially in confined areas. Ensure that
eyewash stations and safety showers are close to the workstation location.
Personal Protective Equipment
Eye/face Protection Wear appropriate protective eyeglasses or chemical safety goggles as
described by OSHA's eye and face protection regulations in 29 CFR
1910.133 or European Standard EN166.
Skin and body protection Wear appropriate protective gloves and clothing to prevent skin exposure.
Respiratory Protection Follow the OSHA respirator regulations found in 29 CFR 1910.134 or
European Standard EN 149. Use a NIOSH/MSHA or European Standard
EN 149 approved respirator if exposure limits are exceeded or if irritation or
other symptoms are experienced.
Hygiene Measures Handle in accordance with good industrial hygiene and safety practice.
9. Physical and chemical properties
Physical State Viscous liquid
Appearance Colorless
Odor Odorless
Odor Threshold No information available
pH 5.5-7.5 50% aq. sol
Melting Point/Range -13 °C / 8.6 °F
Boiling Point/Range 196 - 198 °C / 384.8 - 388.4 °F @ 760 mmHg
Flash Point 111 °C / 231.8 °F
Method - DIN 51758
Evaporation Rate No information available
Flammability (solid,gas) Not applicable
Flammability or explosive limits
Upper 15.30 vol %
Lower 3.20 vol %
Vapor Pressure 0.12 mmHg @ 20 °C
Vapor Density 2.14 (Air = 1.0)
Specific Gravity 1.113
Solubility miscible
Partition coefficient; n-octanol/water No data available
Autoignition Temperature 413 °C / 775.4 °F
Decomposition Temperature > 500°C
Viscosity 21 cP (20°C)
Molecular Formula C2 H6 O2
Molecular Weight 62.06
10. Stability and reactivity
Reactive Hazard None known, based on information available
Stability Hygroscopic.
Conditions to Avoid Incompatible products. Excess heat. Exposure to moist air or water.
Incompatible Materials Strong oxidizing agents, Strong acids, Strong bases, Aldehydes
Hazardous Decomposition Products Carbon monoxide (CO), Carbon dioxide (CO2)
Hazardous Polymerization Hazardous polymerization does not occur.
Hazardous Reactions None under normal processing.
To Next Page
Loading...
