Solid State Logic ORIGIN - Appendix B - Setup Functions; AUTO SLEEP Setup

ORIGIN User Guide
Appendix B
38
Appendix B - Setup Functions
AUTO SLEEP Setup
To setup the AUTO SLEEP timeout, press and keep pressed both the SHIFT and AUTO SLEEP keys. This activates the Bus
Routing keys and LEDs to show AUTO SLEEP timeout where Bus LED's 1-4 are the console's AUTO SLEEP timeout setting and
the adjacent keys can be used to change the AUTO SLEEP timeout.
The LEDs show the timeout in binary format, with the left most LED (1) showing the least signicant digit, and the right most LED
(4) the most signicant digit. Each Binary number from 1 to 1111 is a 5 minute interval. So the AUTO SLEEP timing is represented
by the following table...
Bus LED
Time Until SLEEP
1 2 3 4 (Minutes)
15 seconds**
5
10
15
20
25
30
35
40
45
50
55
60
65
70
75
For example, the LED combination in the picture above means a time until Sleep of 55 minutes (1101)
The factory default Auto Sleep setting is 20 minutes.
** the 15 second setting may be useful to check if Auto Sleep is operating as expected.