EasyManua.ls Logo

Soltaro Hyper Series - 5 Mounting; Requirements for Mounting

Soltaro Hyper Series
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
5. Mounting
5.1 Requirements for Mounting
Check to make sure the installation site does not fall into any of
the following conditions: If any do, then a risk assessment will be
required.
No direct sunlight
No rain exposure
No snow lay up
Direct sunlight
Rain exposure
Snow lay up
Unsafe due to assessment of occupational health safety risks.
The ambient temperature is outside the range of tolerable
ambient temperature (-20°C to +60°C, -4°F to +140°F).
Higher than the altitude of 2,000m above sea level. Above
2000m the inverter output will be de-rated.
Close to flammable materials or areas where flammable
materials are stored.
Prone to be damaged by sea water.
Prone to be flooded or high levels of snow falls.
Close to corrosive gas or liquid (for example, locations where

Related product manuals