Soltaro Hyper Series - 8 Troubleshooting

38
8. Troubleshooting
This chapter is a guide for troubleshooting problems that may
arise in the installation and operation of hyper series inverters.
In the event that more than one error is generated at the same
time, the hexadecimal error corresponding to each alarm are
added together. That is to say, if error code 0006H is displayed,
errors 0002H and 0004H are being produced simultaneously.
Error Code
Description
Solution
F1:00000001
PV1 OVP
Check the configuration of
connected PV Panels.
F1:00000002
PV1 OCPs
F1:00000004
PV2 OVP
F1:00000008
PV2 OCPs
F1:00000010
PV1 OCPh
F1:00000020
PV2 OCPh
F1:00000100
Grid Voltage Abnormal
Check if grid fails.
F1:00000200
Grid Frequency
Abnormal
F1:00000400
DC Bus OVP
These errors will reset itself. If it
keeps coming and finally the
Inverter is latched up, please
contact with your local
distributor.
F1:00000800
AC OCPs
F1:00001000
DC Component of AC
Current Abnormal
F1:00002000
Leakage Current
Protection
F1:00004000
AC OCPh
F1:00010000
EPS Voltage Abnormal
Check the EPS load. Unplug
some to see if too much loads
are connected.
F1:00020000
EPS OCP
F1:00040000
EPS Over Power
F1:00080000
EPS SCP
Error Code
Description
Solution
F1:00100000
Over Heat P1
Wait for the Inverter cools
down. Check if the
installation place is too hot.
F1:00200000
Over Heat P2
F1:00400000
Over Heat P3
F1:00800000
Bat. OTP
These errors will reset itself. If it
keeps coming and finally the
Inverter is latched up, please
contact with your local
distributor.
F1:01000000
Bat. Voltage Protection
F1:02000000
Bat. OCP1
F1:04000000
Bat. OCP2
F1:08000000
Bat. OCP3
F1:10000000
Bat. OCP4
F1:20000000
Internal OVP1
F1:40000000
Internal OVP2
F1:80000000
Internal OVP3
F2:00000001
Grid Grounding Fault
Check the grounding wire.
F2:00000002
L/N Reversely
Connected
Check the L/N wire.