13
chemicals are processed or stored).
• Exposed to direct sunlight or in an enclosure exposed to
direct sunlight.
• Little or no air flow
• Mounted on a surface without suitable fire/heat rating.
• Mounted on a wall without suitable load holding capacity.
• High humidity.
• Sites considered unsafe because of local regulations.
• Confined space without adequate airflow.
• Area subject to sand or dust storms.
• Exposed to steam, vapor, or water.
• Near antenna and/or data cables.、
5.2 Mounting the Inverter
Procedure:
The converter must be mounted in upright position with a
maximal tilt angle of 15 degree.
Minimum clearances around inverter should be applied, as the
following figure shown.
To Next Page
Loading...
