Chapter 4 BIOS Setup
53
Step 4. Type awdflash *.bin /sn/py/cc and then press <Enter> to run BIOS
upgrade program. (*.bin depends on your mainboard model and
version code. Instead of typing “*”, you should type specific file name
for your specific mainboard).
Step 5. Please press <F1> or <F10> to exit or reset your system.
Step 6. You will need a message “CMOS checksum error-Default loaded”
during booting the system. Press <Del> to run CMOS setup utility,
then reload “LOAD SETUP DEFAULTS” or “Load Optimized
Defaults” and save this change.
The parameters of AWDFLASH.EXE
/sn: No original BIOS backup
/py: Program flash memory
/cc: Clear CMOS data (and update data automatically) after pro-
gramming
Users can type AWDFLASH /? to get further details about the parameters.
Incorrect usage of the parameter will damage the BIOS information, so we
strongly recommend user to leave parameters alone unless you fully understand
their function.
Warning ! If the message “ Write Fail ” appears while Award “FLASH
MEMORY WRITER” is verifying Flash memory, just repeat the process.
Please DO NOT reset or turn off the system. If the award memory flash
utility is not able to update the BIOS successfully, your system may not be
able to boot up.
To Next Page
Loading...
