Sonicware LIVEN 8bit warps - Sound Adjustment Details; Changing Effect Type; Changing Effect Parameters; Changing Reverb Type

Adjusting the sound
10
Changing the e󱐯ect type
① While pressing , press to select the e󱐯ect.
The
button lights when the e󱐯ect is not o󱐯.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The e󱐯ect type name is shown on the display.
• 5 types of e󱐯ects can be chosen.
1. OFF
2. CHORUS (CHRS on display)
3. FLANGER (FLNG on display)
4. DELAY (DLY on display)
5. CRUSH (CRSH on display)
Changing e󱐯ect parameters
① While pressing , turn the
RATE/speed and
PITCH/amount knobs.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The speed parameter changes the e󱐯ect time, and
the amount parameter changes the strength of the
e󱐯ect.
• The adjustment range is 0–127.
Changing the reverb type
① While pressing , press to select the reverb.
The
button lights when the reverb is not o󱐯.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The reverb type name is shown on the display.
• 8 reverb types can be chosen.
1. OFF
2. HALL
3. ROOM
4. ARENA (ARNA on display)
5. PLAT (PLAT on display)
6. TUNNEL (TNNL on display)
7. INFINITY (INF on display)
8. TAPE
Changing reverb parameters
① While pressing , turn the FLTR CO/reverb
knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 0–127.
• This adjusts the reverb mix amount and direct
sound.
• In TAPE, this adjusts the noise mix and wow utter
amount.
Changing the sweep speed
① While pressing , turn the
CUTOFF/speed
knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 1–7.
• The time sweep takes to change one step is as
follows.
1. 7.8 ms
2. 15.6 ms
3. 23.4 ms
4. 31.3 ms
5. 39.1 ms
6. 46.9 ms
7. 54.7 ms
Changing the sweep shift amount
① While pressing , turn the RESO/shift knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 0–7.