System settings
28
Setting knob movement function
①
Press
UI, and select the type of knob movement.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• Two types of knob movement functions can be se
-
lected.
1. JUMP : When a knob is moved, the parameter
changes immediately.
2. LATCH (LTCH on screen) : The knob does not af
-
fect the parameter value until its position reach-
es that value. Then, the value follows the knob.
Adjusting the metronome volume
①
Press
METRO. (MTRO appears on the display.)
②
Turn the
VALUE knob to adjust the metronome
volume.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The metronome volume is shown on the display.
• The adjustment range is 0–15.
Enabling/disabling speaker output
①
Press
, and select MUTE or SPK.
Setting the headphone gain
① P r e s s to switch between LOUD to SOFT
settings.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The headphone volume is shown on the display.
• Three volume settings can be selected.
1. LOUD
2. NORM
3. SOFT
• Set this correctly to prevent damage to the head-
phones or external device being used.
Checking the system version
① While pressing , press and hold the POWER
switch.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The LIVEN 8bit warps will start up, and VER. will
appear on the display.
② Press
to select the system version.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The system version (S X.Y) is shown on the display
(X : major version, Y : minor version).
• Press
to check the boot version (B X.Y on
display). Press the 2/6 button to check the preset
version (P X.Y on display).
• Press the same page button again to show the
build number.
• Press
to start up normally.
Restoring to factory default settings (fac-
tory reset)
① While pressing , press and hold the POWER
switch.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• Turn on the LIVEN 8bit warps. F.RST will appear on
the display.
② Press
.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• After resetting completes, DONE will appear on the
display.
• Press
to cancel.
To Next Page
Loading...
