EasyManua.ls Logo

Sonicware LIVEN 8bit warps - Basic Operations; Adjusting Overall Volume; Changing Octave Range; Basic Knob Operation

Sonicware LIVEN 8bit warps
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Basic operations
7
This section explains basic operations.
Adjusting the overall volume
Turn the
VOL knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The levels are shown on the display.
They can be adjusted from ∞ to +6 dB with 0 dB
as the middle values (63–64).
• The adjustment range is 0–127.
Changing the octave range
Press to lower the octave and to raise the
octave.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
The octave can be raised or lowered by ± 3 from
the standard octave.
Depending on the octave, the octave button colors
change from green ( ± 1) to orange ( ± 2) to red ( ±
3). (They are unlit when the octave has not been
changed.)
Basic knob operation
Turning a knob will change the parameter printed in
uppercase letters.
  Turning a knob while pressing
will change the pa-
rameter printed in lowercase letters.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
While pressing
, press to hold . (Press
to return to the normal state.)
Changing patch memories and playing
Press to light the step LED for the currently
selected patch memory.
Press
, , or to select the patch memory
range.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
The patch memory ranges correspond to page but-
tons as follows.
  Patch memories 1–16 :
lit green
  Patch memories 17–32 :
lit green
  Patch memories 33–48 :
lit green
  Patch memories 49–64 :
lit green
  Patch memories 65–80 :
lit orange
  Patch memories 81–96 :
lit orange
  Patch memories 97–112 :
lit orange
Patch memories 113–128 :
lit orange
③ Press a step button to select a patch memory.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The patch number is shown on the display.
The
VALUE knob can also be turned to select
patch memories.
In step ① , press
twice to light orange and
enable continuous selection of patch memories.
In patch memory selection mode, the following func-
tions behave as normal.
1. All knobs (except VALUE)
2. All LEDs (except Page buttons)
3. The keyboard
Adjusting the note velocity
Turn the
VELO knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 0–127.
Sweeping notes while playing
While pressing (lit green), press
(sweep down) or
(sweep up).
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
Press again to end (
and
become unlit).
Patterns recorded with sweep active will also sweep
during pattern playback.
Holding the keyboard
While pressing , play the keyboard to hold key-
board.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
Play the same keyboard to return to the normal
state.
While pressing
, press to release the
hold on all keyboards.

Table of Contents

Related product manuals