Sonicware LIVEN 8bit warps - MIDI Settings; Setting Receiving Channel; Setting Transmitting Channel; Control Change Transmission On;Off

MIDI settings
24
This section explains settings related to MIDI.
Setting the receiving channel
① While pressing , press MIDI, and select RX.CH.
②
Turn the
VALUE knob to change the receiving
channel.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The channel is shown on the display.
• The setting options are ALL, CH.01–CH.16 and
NONE.
Setting the transmitting channel
① While pressing , press MIDI, and select TX.CH.
②
Turn the
VALUE knob to change the transmission
channel.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The channel is shown on the display.
• The setting range is CH.01–CH.16.
Turning control change transmission
on/o󱐯
① While pressing , press MIDI, and select TX.CC.
②
Turn the
VALUE knob to turn it on/o󱐯.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• ON/OFF will appear on the display.
• Control change reception is always enabled.
Turning program change transmission
on/o󱐯
① While pressing , press MIDI, and select TX.PC.
②
Turn the
VALUE knob to turn it on/o󱐯.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• ON/OFF will appear on the display.
• Program change reception is always enabled.
Turning MIDI clock output on/o󱐯
① While pressing , press MIDI, and select TX.CK.
②
Turn the
VALUE knob to turn it on/o󱐯.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• ON/OFF will appear on the display.
Setting MIDI OUT
① While pressing ,
press
MIDI, and select M.OUT.
②
Turn the
VALUE knob, and set MIDI OUT.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• OUT/THRU will appear on the display.
Setting MIDI command
① While pressing ,
press
MIDI, and select M.CMD.
② Turn
the
VALUE knob, and MIDI command.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• Four types of MIDI command settings can be se-
lected.
1.OFF : No receiving or transmitting.
2.RX : Receive only
3.TX : Transmit only
4.RX.TX : Receive and transmit
• Transmit MIDI messages are start and stop.
• Receive MIDI messages are start, continue and
stop.